Welcome, Guest

Poly Top over existing finish?
(1 viewing) (1) Guest
Go to bottomPage: 1
TOPIC: Poly Top over existing finish?
#299
Poly Top over existing finish? 1 Year, 6 Months ago Karma: 0
Can I apply Poly Top over an existing epoxy finish if I sand it first?
info@rawnecessities.com
Fresh Boarder
Posts: 2
graphgraph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
 
#301
Re: Poly Top over existing finish? 1 Year, 6 Months ago Karma: 2
Yes. Just sand it 1st, then apply. best to do 2 coats and then the 1st one 5 to 10% with acetone.
MNewman
Administrator
Posts: 84
graphgraph
User Offline Click here to see the profile of this user
The administrator has disabled public write access.
 
Go to topPage: 1

Cart

VirtueMart
Your Cart is currently empty.

Testimonials

Mike,

I recently did a flagstone overlay job in Capo Beach and just finished a 3 car garage chip system in Laguna Niguel.  I used 5205 and 5073 on both.

GREAT STUFF!  They are a bit more expensive and time consuming (2 passes on sealer instead of 1 with 5000) but they produce a much more even surface with none of the shine hot spots as with 5000.

I just wish the 5073 had a pot life like 45 minute pot life of the 5205.
Stem walls in a garage take the most of time to coat and they both need to be coated with 5205 and 5073.  I'm mixing up smaller batches of 5073 for stem walls but it would be much nicer if they were both consistent since they work together.

Again, thank you for these two great new products.

Patrick Dowd
California Concrete Restoration, Inc.
Laguna Hills, CA