4800 100% Solids Industrial Floor Epoxy 15 G Kit

:

$1 000.87
$667.88

Versatile Building Products 4800 Industrial Epoxy Topcoat is a general use 100% solids clear and pigmented topcoat resin that exhibits great chemical. 4800 is also available in a Non-Yellowing formula for those projects having mild UV exposure. The Non-Yellowing formula is water clear and it is very resistant to yellowing from interior light exposure. 4800 Non-Yellowing is not recommended for exterior use or exposure. 4800 Industrial Epoxy Topcoat is primarily used as a system topcoat or system buildcoat in decorative, commercial, and industrial applications requiring low odor installation and specific chemical
resistance.

4800 Clear is widely accepted for use as an intermediate build coat over flake systems to give a smooth finish by coatings applicators. When used this way be sure to terminate the 4800 at the door edge, do not go onto exterior surface or it will yellow. Use 4800 as a General Use Clear and Pigmented Epoxy.

4800 Epoxy Pigmented
Physical Properties
 Chemical Resistance
Tests Done at 70 Degrees
 Acetone No Effect
Fahrenheit with 1/2 Pint Mass
Pot Life 40 minutes Xylene No Effect
Gel Time
 45 minutes
 10% HCL No Effect
Through Dry (Hours) 8 Ammonia No Effect
VOC 2 g/l Degreaser Faint Spotting
Percent Solids 99/Wt. 99/Vol. Liquid Plumber Faint Spotting
Flammable No Vinegar Faint Spotting
Odor Low Clorox No Effect
Pencil Hardness H-2H Windex No Effect
UV Resistance Poor Motor Oil No Effect
Non Yellowing: Poor Gasoline No Effect
Abrasion Resistance OK
Hot Tire
OK

Install Guide

4800 Install Guide

 

Color Chart

4800 Color Chart

 

Literature

Brochures | | Tech Data | Pics | Chemical Resistance Chart | Cost Per Dry Mil Chart


M.S.D.S.

MSDS 4800 Clear Unit A | MSDS 4800 Clear Unit B

 

Randy took our advice and he was able to apply the 100% Solids Industrial Epoxy to all 20,000 sq ft in less than 5 hours.

Randy with Custom Garages LLC of Texas sent in some photos of a 20,000 sq ft job they just completed. They had a customer who already had an existing epoxy down that was looking pretty dull from the years of wear. The customer did not want to spend a fortune to remove all of it since it was down pretty tight and was not showing any areas of de lamination. Randy spent some time talking to our Technical Director Mark Glendrange and together they were able to come up with a cost effective solution.

Mark recommended that the surface be lightly sanded to de gloss it, also creating micro scratches which will provide tooth for the epoxy to stick to. Then a light solvent wipe was done just prior to the coating application. Mark gave Randy some pointers on how to work a squeegee along with backrolling techniques. This would be the best method of application due to the size of the project.

 

You may also be interested in this/these product(s)

$132.42
$88.36





Back

Cart

VirtueMart
Your Cart is currently empty.

Testimonials


Here are some pictures of the floor that I used the 5205 and 5073 on. This is the old crappy coating. This is what it looked like after stripping it (ewwww!): This is what it looked like after restaining and before application of 5205: Now, 1 hour after application of 5073 (look at the reflection on the walls!) I am astounded at how great it looks!"


Joe Concrete Illusions of Illinois