4001 Waterbased Wet Look Epoxy 2 Gallon Kit


$135.85
$90.65

This is better than a Laqcuer and costs about the same

Stop using 5 different products to cover your residential, commercial, and light industrial concrete work! You need a Versatile sealer that can perform and multi-task your sealing needs. 4001 Clear utilizes a crosslinking technology that allows it to breathe out moisture emissions found on high MVT slabs. 4001 will provide give your concrete surface a Wet Look while providing a medium to high gloss that will accept medium foot traffic in retail areas.

 

4001 Clear
Physical Properties
Chemical Resistance
Tests Done at 70 Degrees
 Acetone Faint Spotting
Fahrenheit with 1/2 Pint Mass
Pot Life 120 minutes Xylene No Effect
Gel Time (Hours) Does not gel 10% HCL Spotting
Through Dry (Hours) 12 Ammonia No Effect
VOC g/L 22 g/l De greaser No Effect
Percent Solids 26/Wt. 24/Vol. Liquid Plummer No Effect
Flammable No Vinegar Faint Spotting
Odor Low Clorox Faint Spotting
Pencil Hardness H-2H Windex No Effect
UV Resistance Poor Motor Oil No Effect
Non Yellowing Poor Gasoline No Effect
Abrasion Resistance Good Hot Tire No Effect

 

Brochure

4001 Clear Waterbased Concrete Floor Epoxy Brochure


Install Guides

4001 and 5000 Install Guide

4001 and 5073 Install Guide

4001 and 5400 Install Guide


Literature

Training Sign Up Form| Tech Data | Chemical Resistance Chart

MSDS

MSDS 4001 Unit A| MSDS 4001 Unit B


You may also be interested in this/these product(s)

$617.20
$411.86







Back

Cart

VirtueMart
Your Cart is currently empty.

Testimonials

Mike,

I recently did a flagstone overlay job in Capo Beach and just finished a 3 car garage chip system in Laguna Niguel.  I used 5205 and 5073 on both.

GREAT STUFF!  They are a bit more expensive and time consuming (2 passes on sealer instead of 1 with 5000) but they produce a much more even surface with none of the shine hot spots as with 5000.

I just wish the 5073 had a pot life like 45 minute pot life of the 5205.
Stem walls in a garage take the most of time to coat and they both need to be coated with 5205 and 5073.  I'm mixing up smaller batches of 5073 for stem walls but it would be much nicer if they were both consistent since they work together.

Again, thank you for these two great new products.

Patrick Dowd
California Concrete Restoration, Inc.
Laguna Hills, CA

VBP Forum

Re:5400 v 5073
calconcrete 05.15.2012 17:57
5400 v 5073
GSNE 05.14.2012 21:59
Re: Thirsty stem walls
MNewman 05.14.2012 15:32
Thirsty stem walls
calconcrete 05.12.2012 17:21
Re:MVE ?
MNewman 05.07.2012 19:53